How to replace the HP printer transport belt
Issue Time:2011-05-12

All parts of the printer can not go on forever. If your HP printer carriage belt is worn and you do not want to pay have it replaced, you can buy yourself a new belt installed. Replace the printer carriage belt should only be adopted by others reasonably good mechanical skills.

Replace the following steps:??

All parts of the printer can not go on forever. If your HP printer carriage belt is worn and you do not want to pay have it replaced, you can buy yourself a new belt installed. Replace the printer carriage belt should only be adopted by others reasonably good mechanical skills.
?1, unplug the printer's power cord and disconnect all cables connected to the computer. Wait fifteen minutes, to ensure that the printer has cooled down completely before.
2, delete the computer's cover. In some models, which need to find the plastic tab buy the cover. Other models have a hinged access door, only to rise.
3, find the printer conveyor belt. Find clips to control the car. What the clip screws holding class notes, and some printers and others with a Phillips screw with plum screws.
4 Remove the screws, place the printer conveyor belt. Careful not to drop any screws to the printer, because they may be hard to find.
5 Unscrew the conveyor belt, replaced by new transport belt. Be careful where in the same way, by old and new is the conveyor belt clip.
6, all the screws back to their original point, to ensure the strengthening them so they will not become loose. Remember, with a mobile printer during transport to keep running.
7, the replacement of the printer's top cover. Plug wires back in and reconnect the printer's computer.

Search: hp printer parts, fuser film sleeve, fuser assembly, printer parts ,printer's repair

hp printer parts